|
|
|
|
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
|
#1
08-19-2016, 05:18 PM
|
||||
|
||||
|
Finally digging into my 722.315 transmission (broken pump driving tabs)
This was sitting for a couple of years because I kind of lost interest in the projects, but IT'S BACK ON!
Got the pump put. The tabs on the inner gear are broken off. Have a replacement coming from ebay -- not a whole brand new pump, that's super expensive; found a guy with used parts with tabs intact. I kind of want to dig in a bit deeper; I am just wondering whether I should get a gasket set only, or a set with the metal bits? The transmission was shifting fine right before the pump quit; am I likely to need to replace any of the metal parts? Should I, 'while I am in there' ?
__________________
'82 300D (project) '46 Willys (project) "Nothing seems to be the way it should in this garage." -jt20 "Smarter than an engine, dumber than a hoodlatch..." -jt20 "Start jumping up and down to smoosh down those engine mounts" -DeliveryValve "no" -kerry "At this rate, you may have it done by winter" -layback40 
|
|
#2
08-19-2016, 05:39 PM
|
||||
|
||||
|
Or, to put the question differently - what should I definitely replace while I have it apart?
__________________
'82 300D (project) '46 Willys (project) "Nothing seems to be the way it should in this garage." -jt20 "Smarter than an engine, dumber than a hoodlatch..." -jt20 "Start jumping up and down to smoosh down those engine mounts" -DeliveryValve "no" -kerry "At this rate, you may have it done by winter" -layback40
|
|
#3
08-20-2016, 01:00 PM
|
||||
|
||||
|
Nice to you back.
I would suggest updating the B2 piston and sleeve. Here is a good thread for you to look through regarding going through the .315 http://www.peachparts.com/shopforum/diesel-discussion/370024-going-rebuild-my-722-315-a.html .
__________________
1983 123.133 California - GreaseCar Veg System 
|
|
#4
10-09-2016, 11:16 PM
|
||||
|
||||
|
Finally got it put back together. She runs and drives!!! I am so excited.
I need to sort out the kill switch, I know it used to work, I must have just put it together wrong. Also the fuel gauge not working. All small things, I am sure I will be able to sort them out. SHE RUNS!!!!!! And drives too!!!
__________________
'82 300D (project) '46 Willys (project) "Nothing seems to be the way it should in this garage." -jt20 "Smarter than an engine, dumber than a hoodlatch..." -jt20 "Start jumping up and down to smoosh down those engine mounts" -DeliveryValve "no" -kerry "At this rate, you may have it done by winter" -layback40
|
|
| Bookmarks |
|
|
Hybrid Mode
