|
|
|
|
|
#1
05-12-2004, 09:48 AM
|
|||
|
|||
|
Engine mis fire at low revs 300CE Coupe
Hi,
I have an '89 300CE Coupe 3sp Auto. At low revs and worse when engine is warm I get a bad mis fire - the engine has no power at all. The only way to get going is to use very light throttle to get the speed and revs up a little or use low range - once over about 1500rpm it performs fine with no hint of the problem. Also the car is a little reluctant to start - have to use lots of pedal I'm suspecting high tension plug leads - am I correct? Cheers Rich Last edited by crazyquiff; 05-12-2004 at 10:09 AM. 
|
|
#2
05-12-2004, 04:49 PM
|
|||
|
|||
|
Check your plugs, if one of them is moist your head gasket is gone. I just replaced one on my 92 300 CE that had the same problem.
Cheers, Steve
__________________
97 S500 Coupe 139Kmi. 92 300CE 150Kmi. Sold 89 F250 Diesel 220Kmi. Dead 98 GMC 1500 160K.
|
|
#3
05-13-2004, 04:43 AM
|
|||
|
|||
|
Steve,
Thanks for the note. I've also read a post about the cold start injector leaking and causing the problem - checked that last night and doesn't seem to be the case. But, Steve, I can't get the logic behind the head gasket being the problem. The symptoms just don't seem right to me. I suspect maybe a vacuum leak somewhere. Could you have corrected the problem while changing the gasket? Has your problem been totally solved now? Was it exactly the same? Cheers Rich
|
|
#4
05-20-2004, 09:52 AM
|
|||
|
|||
|
Problem sorted - damp in the dizzy cap - so i dried it out and cleaned up all the posts and rotor arm.
No cost solution!
|
 |
| Bookmarks |
|
|
Linear Mode
