|
eatont9999, Thanks for the photos, and I will offer a couple of observations. 1) Check and make sure there are enough threads in the lock nut on the long bolt. If you use the flat washer and the lock washer, there might not be enough thread for the lock nut to do it's job. 2) The oil cooler lines are supposed to go on top of the bracket, not on the bottom. It appears that they are bent downward. If you are ok with them like that, then no harm done. 3) The rear compressor bolt needs to be put in the hole in the tab before installing the plate on the engine. I am sure you found out that you needed to remove the lower left plate mounting bolt in order to get the comp bolt in. It also may be easier to mount the comp on the plate, and install the compressor and plate as a unit. I have done it both ways, and it seems to be easier with the comp and plate together. 4) The third hole (closest to the crank) in the brace is there for the end of the factory screw to go into. It appears that your brace is sticking up a bit right above the pan. It is best to line all three screws in their holes before tightening any of the nuts. Also, leave the larger bolt loose in the plate, and tighten it last. There is no nut or new screw for the third hole, as it will hit and bend or break the tach pin....Rich
|