|
|
|
|
|
#1
11-12-2001, 04:03 PM
|
|||
|
|||
|
How hard to replace warped vinyl window molding?
Almost all the 123's I've seen have suffered from this phenomena. The interior-colored moldings that go on the inside of the window frames become wavy and warped. Has anyone replaced these before? Is it necessary to remove the rubber door seals and the window channel? Thanks for any help.
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How hard is it to replace the rear windshield seal? | DieselHead | Diesel Discussion | 11 | 11-23-2002 06:34 PM |
| How hard is it to replace the Delco AC compressor? | speedy300Dturbo | Diesel Discussion | 4 | 05-10-2002 10:20 PM |
| Window Switches Sticky - Clean, or Replace? | David C Klasse | Tech Help | 3 | 03-27-2002 03:17 PM |
| how do I replace window seal???300SD Help | glassman | Diesel Discussion | 0 | 09-02-2001 02:22 AM |
| How hard is to replace transmission front pump seal on a 1988 300E? | Steve190E 2.3 | Tech Help | 3 | 04-03-2001 08:23 AM |
Threaded Mode
