|
|
|
|
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
|
#1
11-05-2000, 03:58 AM
|
|||
|
|||
|
Need help with 300E headgasket replacement, FSM says measure head bolt stretch
I have a 1988 I have just replaced the headgasket. I read in the manual to measure head bolts before reusing them. They measured within spec. I was on my last sequence where you torque them one last 90 degrees and I got interupted. I don't remember which one I was on in the order it says in the book. I may have missed one or two. I relize the head bolts are torque to yield therefore I do not want to repeat the torqueing sequence. What should I do? Will it be OK if I maybe missed the last step on 1 or 2 bolts? I am probably getting myself worried for nothing. The bolts are already very tight.
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| '91 300E 3.0 check engine light, code 17, after 02 sensor replacement | kristian85 | Tech Help | 1 | 07-16-2004 11:40 AM |
| 300E AC evaporator replacement ... and dashboard | bigschot | Tech Help | 5 | 08-25-2003 09:20 PM |
| 300E Airflow Sensor Replacement - The Old Guy's on Viagra! | ctaylor738 | Tech Help | 0 | 08-13-2003 06:07 PM |
| 1988 300E exhaust system replacement | asiamood | Tech Help | 3 | 11-05-2002 04:44 PM |
| Stereo System Replacement in 300E is Complete! | buddysdad5005 | Car Audio and Multimedia | 4 | 10-27-2002 08:42 AM |
Threaded Mode
