![]() |
|
|
|
|
#1
|
|||
|
|||
M103 Fan Bearing Bracket Sealant
Engine M103, 1992 300E
I am going to replace this assembly due to noisy bearing. I have the tool for locking the fan pulley. MB Shop manual calls out a sealant for one of the bolts. Apparently this bracket has a bolt in common with the belt tensioner. In job no. 13-345 they refer to the sealant with two different part nos. 001 589 29 20, then one page later as 001 989 29 20. Looks like a typo. Searched the archives to no avail. Not really concerned with which one is correct, but what non-MB sealant should I use? Thanks, Steve |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY Notes may help people: Radiator, Fan Clutch, Temp Sensors, Fuel Pump, Temp Gauge | ericgr | Mercedes-Benz SL Discussion Forum | 3 | 09-24-2004 01:40 AM |
1992 300 m103 vacuum line/ fan shroud clip | fish4stripers | Tech Help | 11 | 09-20-2004 12:57 PM |
Auxiliary Fan Question | JBoggs | Tech Help | 9 | 07-30-2003 10:07 PM |
M103 (W124) fan belt tension setting | taaboo | Tech Help | 2 | 12-15-2000 10:09 PM |
M103 fan bearing R&R | sixto | Tech Help | 0 | 11-06-2000 08:27 PM |