|
|
|
|
|
#10
10-10-2007, 11:18 PM
|
||||
|
||||
|
guess thats understandable
its been running ok bet it runs better well after wires are on its going no where now... will need to get the plugs changed so they don't mess new cap how can u tell if the plugs r too hot? don't know whats in there but plugs r probably old  Now I read something about dielectric grease on rotor???? No way I;m taking that off again... ??????? anti seize to screws of cap???? arrrghhh don't think they seize too much???? I just didn't want to put antiseize or grease where it wasn't supposed to be as could cause problems??? Did I make a bad mistake?
__________________
~Shadow~  83 500 SEC Euro 198K Last edited by CamelotShadow; 10-10-2007 at 11:35 PM. 
|
| Bookmarks |
|
|
Threaded Mode
