|
|
|
#1
|
|||
|
|||
Looking for coolant drain bolt on M103 block?
I can't seem to locate the block drain bolt on my '91 300E (M103 engine).
I need to drain the ENTIRE system to flush, due to the ATF in the oil issue I have recently repaired. Could someone describe to me please where this drain bolt is located? Thanks! ~~Iodyn Also, I just received the MB degreasing agent and citric acid powder as I was typing this. They both come in powder form but don't explain how to use it. Should I mix these agents with say, 1 gallon of water, then pour into radiator? Certainly I wouldn't pour the powder in without mixing it with another solution would I? Thanks for your help.... Last edited by iodyn; 08-03-2001 at 01:30 PM. |
#2
|
||||
|
||||
Looking at the engine from the front with hood up, go to passenger side. Just underneath exhaust manifold, in between cyl 5 and 6. Look for drain plug in this area. 19mm socket takes it out.
__________________
Mike Murrell 1991 300-SEL - Model 126 M103 - SOHC "Fräulein" |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Where is the engine block drain plug on the W202? | tseinsf | Tech Help | 3 | 06-24-2003 07:56 PM |
617 block coolant drain? | B300FO | Diesel Discussion | 5 | 05-29-2003 11:59 AM |
Best way to remove stripped oil drain bolt | CD_NY | Tech Help | 8 | 11-07-2000 08:13 PM |
Cam sprocket bolt tightening procedure on M103 | LarryBible | Tech Help | 3 | 10-26-2000 06:44 AM |
14mm hex drain bolt | iozero | Tech Help | 13 | 06-19-2000 05:08 PM |