|
|
|
#1
|
||||
|
||||
Installing my euros in 123 ???
I seem to need some fasteners on the inside of the light assembly. The holes are f ing huge! I am reluctant to use 3/8" bolts. Anybody have the hot set up?
Tom W
__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC] ..I also have a 427 Cobra replica with an aluminum chassis. |
#2
|
||||
|
||||
you should be able to use the clips that the us spec lights use to thread the bolt.
the katmacs I bought came with the clips oh.. wait.. on the inside? what? |
#3
|
||||
|
||||
The holes are large so the housings can be adjusted up, down, and sideways. A clip mounts on the crossmember to which the lights mount. I don't remember if it is the same one used by the USA lights, but just a long sheet metal screw with a washer is what you should use - no 3/8 bolts.
__________________
Don't Chrome them; polish them |
#4
|
||||
|
||||
OK. Thanks, guys.
I'll try that. Tom W
__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC] ..I also have a 427 Cobra replica with an aluminum chassis. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|