|
|
|
|
|
#1
08-29-2001, 11:13 PM
|
|||
|
|||
|
anyone know how a self-level (auto-level) car is suppose to work????
I've recently had some doubts about the auto-level in my 1998 E320 Wagon so I had someone (200 lbs) sit in the third row seat with the car off; the car had been off for several hours. Then I started the car. The rear end NEVER came up to the unloaded height; it didn't move at all but, it did make a few clicking sounds like a struggling motor for a few seconds.
Is this normal? Is this even a way to check the auto-level system? Any ideas?? Intruder Last edited by intruder; 09-01-2001 at 09:27 AM. 
|
|
#2
08-29-2001, 11:38 PM
|
|||
|
|||
|
I'm not that familiar with the 98 model but the older models (not that older) use a hydralic pump and 2 pressure accumulators in the back for the leveling system. In my experience if your not losing fluid most of the time the accumulators are bad.
|
|
#3
08-30-2001, 05:58 PM
|
|||
|
|||
|
Agree with above,just done mine ,$175 in parts and just under 3 hours,easy if a little messy!!
Regards HAMISH
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oil level and '02 C230 | jcapp | Tech Help | 11 | 09-19-2003 04:19 PM |
| Auto Level Suspension | smartin | Diesel Discussion | 14 | 02-12-2003 04:53 PM |
| 1988 190E coolant level sensor | mertztr | Tech Help | 2 | 02-27-2002 01:32 AM |
| OM603 - oil level sensor oddity | gsxr | Diesel Discussion | 5 | 01-16-2002 01:06 AM |
| Checking trans fluid level | ARJAY | Tech Help | 2 | 08-01-2001 09:08 AM |
Linear Mode
