![]() |
|
|
|
#1
|
|||
|
|||
Fault code 007 help please
I've been experiencing the following problem on my 1995 SL 500 and my tech hasn't been able to isolate the problem:
After a cold start and driving the car for several minutes, if the engine is shut down and restarted hot the car goes into limp home mode (minimum power, rough idle). If allowed to cool down and restarted, problem disappears. I had the codes recalled and I'm getting a code "007 - Ignition system defective, fault from fuel/ignition control system" Any ideas where I should start would be greatly appreciated. Thanks in advance, Chris |
#2
|
|||
|
|||
There are 2 coils, distributor caps, & rotors. Any failure on any of these can allow only 4 cylinders to run instead of 8, is this what is happening?? Of course the ignition control unit must send signal to both coils so that all 8 cylinders will run.
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fault Code 17 (data exchange problem) & Dealer B.S. | RunningTooHot | Tech Help | 4 | 08-05-2015 08:47 PM |
Fault Code 9 – EHA Current illogical | Tony Smith | Tech Help | 25 | 11-19-2012 07:43 AM |
Help with Fault Code | Eiknujrac | Tech Help | 26 | 07-25-2004 05:51 PM |
Fault code 13 - Lambda control at limit | 95e320 | Tech Help | 23 | 09-30-2003 03:32 PM |
'97 C230, Fault Code P0170 and Self Adaptation | jgl1 | Tech Help | 1 | 06-03-2003 08:02 AM |