|
|
|
|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
how to access a/c diagnostic codes from the pushbutton display console
I have a 92 300se that all of a sudden, the a/c clutch cycles after a cold startup after about 5 minutes, then it will cycle every 10-15 seconds. Then freon is full, this started right after a wire broke off the terminal at the compressor but was fixed ( resoldered the wire back on to the connector). What may be the cause of this and what buttons on the consloe do i need to push to go into diagnostic mode? Any help would be greatly appreciated.
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
C230 A/C Diagnostic display (Climate control)--How to use | rpmillie | Tech Help | 48 | 06-20-2012 07:17 PM |
R&R of center console trim tips for access to HVAC head and window switches | pookydink | Tech Help | 1 | 01-15-2003 07:49 AM |
R&R of center console trim tips for access to HVAC head and window switches | pookydink | Tech Help | 0 | 01-14-2003 09:29 PM |
C230 diagnostic display | CV2 | Tech Help | 4 | 12-08-2001 10:54 PM |
w140 A/C Pushbutton Unit Removal | sail42 | Tech Help | 2 | 10-31-2001 09:27 PM |