|
|
|
#1
|
|||
|
|||
I have a 92 190E2.6 that has a slight stumble/roughness at idle that started 15k miles ago. The car has 75k miles now. I have changed the plugs with no change. Car runs fine and gas milage is good(24 to 28). No computer codes and egr is closed and not leaking. Idle speed is normal(700 rpm) and fuel pressure is 75psi and EHA current is at -3 to -5 ma when warmed up(I have sensor plate adjusted richer for a delta of -2ma from factory setup for faster starting @40k miles). I had replaced o2 sensor at 50k for surging at idle(cured). Any ideas of how to clear up this slight stumble would be apprediated.
|
#2
|
|||
|
|||
Engine mounts on this model are as critical for rough idle as engine fuel mixture. These engine mounts are hydraulic and contain fluid and check valves. THEY FAIL OFTEN!
|
#3
|
|||
|
|||
POSSIBLY THE FUEL INJECTORS HAVE A FAULTY SPRAY PATTERN OR INCORRECT OPENING PRESSURE. ALSO CHECK THE RESISTANCE VALUES OF THE IGNITION WIRE ENDS. SHOULD BE ABOUT 1K OHM FROM THE CAP TO THE PLUG CONNECTORS, ON EACH CYLINDER.
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
'83 380 SL fast idle problem | Dorbell | Tech Help | 3 | 08-23-2004 09:25 PM |
1967 230s idle problem | techrondon | Vintage Mercedes Forum | 17 | 03-29-2004 10:25 AM |
380 Idle Control Valve Test | ctaylor738 | Tech Help | 5 | 01-23-2004 01:33 PM |
190E2.6 idle roughness and emissions issues | Duke2.6 | Tech Help | 2 | 03-23-2003 10:30 PM |
190E2.6 stumble at idle | rolfe3 | Tech Help | 1 | 05-11-1999 09:00 PM |