|
|
|
|
|
|
|
#1
05-17-2000, 08:40 PM
|
|||
|
|||
|
You need a tool called Glow Plug Reamer to clean the prechamber opening before installing the new plugs. I do not know why you need to clean it but there must be a reason for doing so. It is possibly a $50 tool. Also, I would disconnect the battery's negative terminal before working on the plug, just to be safe.
Good luck David [This message has been edited by be459 (edited 05-17-2000).] 
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Glow Plug Component Location - W123 | toytech | Diesel Discussion | 4 | 03-09-2005 03:48 PM |
| 92 300D 2.5 glow plug problem | invisik | Diesel Discussion | 37 | 05-26-2004 12:48 PM |
| Glow Plug & Check Engine Light On - Relay??? | JHZR2 | Diesel Discussion | 0 | 05-12-2004 11:09 PM |
| Glow plug resistance test | Crowe | Diesel Discussion | 3 | 09-15-2002 07:58 PM |
| 1986 300SDL Glow Plug dash Board Light | Marvin Smith | Tech Help | 1 | 01-31-2002 05:27 PM |
Hybrid Mode
