|
|
|
#1
|
|||
|
|||
Is it possible to replace the bushings on the the mercedes rear spring arm by maintaining weight on the car and placing a scissors jack under the spring arm, then uncoupling the bolt thru the bushing...then lowering the arm slowly about 1.5 inches... yes or no?
Many thanks. If not.. best way? |
#2
|
|||
|
|||
Always use a spring compressor when dealing with springs. They are powerful and can suprise you if you don't get things quite right. This is not a place to cut corners. Be safe.
------------------ Jeff Lawrence 1987 300e 1989 300e 1987 BMW 325 |
#3
|
|||
|
|||
Here's an excerpt from the "Safety Procedure Bulletin" that came with my H&R springs:
"The removal and installation of suspension springs can be very hazardous. Springs under compression have a tremendous amount of stored energy that when handled improperly can be released abruptly damaging people and property . . ." They also recommend having their products installed by qualified licensed mechanics. Just food for thought. Brian |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rear brake questions for 92 190E | VettesRule | Tech Help | 6 | 12-08-2004 10:33 PM |
190E rear camber problem - worn-out struts? | Erik VanR. | Tech Help | 3 | 09-14-2002 02:17 AM |
bad rear diff in 1990 190E 2.6 | crhenkel | Mercedes-Benz Performance Paddock | 0 | 08-29-2001 01:32 PM |
Rear Axle Level Control 190E 2.6 | KM | Tech Help | 2 | 10-07-2000 11:24 PM |
'90 300se Rear Sags | kevinjh | Tech Help | 4 | 05-09-2000 09:32 AM |