Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums

Showing results 1 to 30 of 196
Search took 0.04 seconds.
Search: Posts Made By: Adler
Forum: Vintage Mercedes Forum 10-23-2015, 10:08 AM
Replies: 3
Views: 1,259
Posted By Adler
NGK is supurb in quality and for use in our older...

NGK is supurb in quality and for use in our older models .Do note the above advised plug does not have a 'R'' in the number important for correct operation.

Bosch plugs sourced from Germany...
Forum: Vintage Mercedes Forum 10-23-2015, 09:57 AM
Replies: 13
Views: 2,174
Posted By Adler
Most mb Solex and zenith carbs are prone to...

Most mb Solex and zenith carbs are prone to warping and extremely difficult to correct, Weber replacements are a much better option from jam engineering.
Forum: Vintage Mercedes Forum 10-23-2015, 09:35 AM
Replies: 15
Views: 1,668
Posted By Adler
Mine is in anthracite grey,European model...

Mine is in anthracite grey,European model 300se/90.
It really is a lovely model to drive , gaskit failure is Not a frequent repair or required on a well maintained car.
Forum: Vintage Mercedes Forum 07-13-2013, 07:02 AM
Replies: 36
Views: 6,318
Posted By Adler
zeniths faults and warpage

Once a 180 or 130 engine overheats badly the zenith's will likely warp and cause various starting and running faults which even a new kit will not rectify.
The warpage needs to be trued and...
Forum: Vintage Mercedes Forum 01-14-2013, 09:44 AM
Replies: 2
Views: 979
Posted By Adler
squirt some carb cleaner in the carb bore to...

squirt some carb cleaner in the carb bore to see if it will catch on .this will isolate ignition or fuel problem .
I assume this is a the 4 cyl engine with a Stromberg carb.
Ad
Forum: Tech Help 01-13-2013, 08:13 AM
Replies: 33
Views: 9,653
Posted By Adler
old engines require ZDDP additive .Do the newer...

old engines require ZDDP additive .Do the newer oils have thator just the diesel oils?
Ad
Forum: Tech Help 01-13-2013, 08:03 AM
Replies: 2
Views: 1,001
Posted By Adler
i had that on my OVP relay ,red fuse was good...

i had that on my OVP relay ,red fuse was good ,insidethe solder joint was bad . re-soldered it was back to first time cold start
Ad
Forum: Tech Help 01-12-2013, 12:13 AM
Replies: 18
Views: 2,126
Posted By Adler
300 idle

A barely perceptible tremor at idle was sorted out when fresh non- resistor plugs were installed .
Now if someone could come out with the correct low resistance leads so that the readily...
Forum: Tech Help 01-10-2013, 11:15 PM
Replies: 5
Views: 2,198
Posted By Adler
vacuum gauge

a single vacuum connection from manifold should suffice .
Forum: Tech Help 01-07-2013, 10:51 PM
Replies: 14
Views: 1,899
Posted By Adler
I would ref mark the belt and remove to spin...

I would ref mark the belt and remove to spin check each pulley individually .
Ad
Forum: Tech Help 01-05-2013, 11:16 PM
Replies: 9
Views: 4,268
Posted By Adler
I may as well add a set of fresh brass tipped...

I may as well add a set of fresh brass tipped fuses to replace all the eroded ones causing intermittent faults

Ad
Forum: Vintage Mercedes Forum 01-05-2013, 08:53 AM
Replies: 17
Views: 4,196
Posted By Adler
A photograph of the finish will be appreciated...

A photograph of the finish will be appreciated .

Ad
Forum: Mercedes-Benz Used Parts For Sale & Wanted 11-29-2012, 12:55 AM
Replies: 3
Views: 510
Posted By Adler
Thanks . I thoght al lot more would be...

Thanks .
I thoght al lot more would be required i.e bracing supports. etc
Forum: Tech Help 11-28-2012, 09:16 PM
Replies: 5
Views: 864
Posted By Adler
radiator efficency

Is there more informtion on that ?
Forum: Vintage Mercedes Forum 11-27-2012, 11:32 PM
Replies: 25
Views: 3,859
Posted By Adler
F&S shocks

Any input about F&S shocks for the vintage models ?Anyone with ride opinion on their cars, a soft , or very firm ride?
Ad
Forum: Mercedes-Benz Used Parts For Sale & Wanted 11-27-2012, 11:25 PM
Replies: 3
Views: 510
Posted By Adler
WTB W108 windscreen

Require a clean 108 front screen but would like to hear from a experinced hand how it can be packed & shipped correctly to avoid transportation cracks or breakage .

Thanks
Adler
Forum: Tech Help 11-25-2012, 08:20 PM
Replies: 13
Views: 2,943
Posted By Adler
If the rotor and cap are new then next check for...

If the rotor and cap are new then next check for a clogged exhaust ,easily checked with a vacuum gauge.
ad
Forum: Vintage Mercedes Forum 11-23-2012, 10:42 AM
Replies: 33
Views: 5,927
Posted By Adler
Polstermanufactur.de very impressive original...

Polstermanufactur.de
very impressive original quality carpets and seats. Pity we cant get the very same quality products here .
Ad
Forum: Tech Help 11-22-2012, 05:33 AM
Replies: 7
Views: 1,183
Posted By Adler
Most likely the reverse disks will be gone too,...

Most likely the reverse disks will be gone too, seal kit is best; wonder if the new plate material is better and lasts longer .
Ad
Forum: Tech Help 11-21-2012, 09:48 AM
Replies: 13
Views: 4,130
Posted By Adler
the additional resistance of the R -type plug ...

the additional resistance of the R -type plug causes performance and idling problems ,not so apparent till you install the correct non- R plugs
ad
Forum: Vintage Mercedes Forum 11-14-2012, 03:23 AM
Replies: 3
Views: 911
Posted By Adler
On my 300se it was the alternator which showed...

On my 300se it was the alternator which showed the correct voltage but low aperage
Ad
Forum: Vintage Mercedes Forum 11-14-2012, 03:08 AM
Replies: 3
Views: 879
Posted By Adler
best model

Welome to the most informative forum with lots of expertise.
Forum: Tech Help 11-09-2012, 03:28 PM
Replies: 21
Views: 3,648
Posted By Adler
telltale warning may be a very light vibration...

telltale warning may be a very light vibration on the shift lever.
Forum: Tech Help 11-09-2012, 03:18 PM
Replies: 33
Views: 9,243
Posted By Adler
Helpful to all if it gets posted here

Helpful to all if it gets posted here
Forum: Vintage Mercedes Forum 11-08-2012, 09:01 PM
Replies: 6
Views: 2,211
Posted By Adler
The. 108 service manual has a detailed. Repair...

The. 108 service manual has a detailed. Repair section. On zenith service.
Ad
Forum: Vintage Mercedes Forum 11-08-2012, 08:37 PM
Replies: 6
Views: 2,211
Posted By Adler
Likely the idle fuel feed is clogged up. ...

Likely the idle fuel feed is clogged up. Requires cleaning of Brass idle tube and its fuel intake inside the main jet. Well.
Idle mixture discharge ports may be clogged up.
A good...
Forum: Vintage Mercedes Forum 10-31-2012, 11:04 AM
Replies: 41
Views: 7,085
Posted By Adler
[QUOTE= 2. You will meet the worst scum...

[QUOTE=

2. You will meet the worst scum bags, snake oil salesman and thieves who will be happy to sell you paint-covered rust for more than you paid for the car.

So very true .
I had very ...
Forum: Tech Help 10-30-2012, 11:36 PM
Replies: 36
Views: 3,477
Posted By Adler
final bleed

[QUOTE=]the only way I can get a firm pedal.Is take a 2X4,and wedge the brake pedal down,and the other end to the seat.Leave it this way overnight..

I would suggest this very method ,works every...
Forum: Tech Help 10-28-2012, 12:03 AM
Replies: 10
Views: 2,265
Posted By Adler
further check

Hi
leaving the ignition on for 10 minutes is not good . the fuel pump gets activated for 5 sec only and then again when the starter is activated .

check the rotor for high resistance...
Forum: Vintage Mercedes Forum 10-27-2012, 10:23 AM
Replies: 13
Views: 1,744
Posted By Adler
Smile Hmmm... perhaps quite chic for a Al -sheik ...

Hmmm... perhaps quite chic for a Al -sheik

Ad.
Showing results 1 to 30 of 196

 
Forum Jump


All times are GMT -4. The time now is 04:57 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page