|
|
|
#1
|
|||
|
|||
This is a little long and complicated, so bear with me. As some of you may remember, many months ago someone put superglue (or something) in my driver's and passenger side door locks. I didn't get it fixed immediately because I could still open the doors from the trunk, and the cost of a new door handle plus installation was around $500.00. Well, last month someone hit my driver's side door, and I figured that since the door handle would have to be removed to replace the door panel, this would be a good chance to replace the handel and not have to pay for the labor. So, it was done, the door looks as good as new, but there is a strange problem with the central locking. I could take it back to the body shop and have them fix it, but I'd rather not be without my car for a day is this is something I can fix myself. Okay, so here is the problem:
If I use my key to lock or unlock the driver's door, all doors and the trunk unlock (normal), however, when I am in the car and I push down the door lock on the drivers door, the other locks do not lock. If I push down the passenger side door lock before I start the engine, all locks will lock (normal), however if I push down the passenger side door lock after the car is started, only that door locks (also normal), but as soon as I turn off the engine all the other doors lock. Finally, if I lock the front passenger side door when leaving the car (by pushing down the lock and closing the door, as the key still does not work on that side), all doors lock, but the next time I unlock the driver's side door with the key, only that door will inlock, and sometimes it will try to "suck" itself locked again. If anyone has any ideas, please let me know. The car, by the way is a 560SEL. Thanks! Justin |
#2
|
||||
|
||||
I don't think I can be of much help, but I would bet they wired something wrong. Sounds quite off and unable to get a pattern out of the problems. I can only think of wiring. Good luck though.
__________________
2006 E350 w/ 155k miles (Daily Driver) Previous: 1993 300E 3.2L Sedan w/ close to about 300k miles 2003 E500 Brilliant Silver (Had 217k miles when totalled!) 1989 300E with 289,000 miles (had for <1 yr while in HI) 03 CLK 500 cabrio (Mom's) 2006 C230k (Dad's) 1999 S420 (Mom's/Dad's) 2000 C230k Sport sedans 2001 CLK320 Cabrio (Mom's) 1995 C280 My First Mercedes-Benz... (155k miles. EXCEPTIONAL AUTOMOBILE. Was Very hard to let go of!) |
#3
|
|||
|
|||
I would have the body shop fix it. The central locking system with its vacuum and electrical connections is complicated to diagnose. It could be a loose vacuum fitting somewhere, probably where they replaced or a bad loose connection somewhere. It could be something else in the system going going bad.
__________________
1990 190E 2.6 1996 Grand Voyager 3.3 1985 Mustang GT 5.0 5 SPD 1982 Suzuki GS 750T |
#4
|
|||
|
|||
Well, JDUB, it looks like I'll be taking your advice. Yesterday it rained for the first time since I got my car back, and there is a small leak somewhere. So, the locks and the leak will have to be taken care of by the body shop. Thanks again-
Justin |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
190E wiring query - central locking | greenpc | Tech Help | 4 | 12-11-2014 02:05 AM |
central locking on 126 | downsmith | Tech Help | 3 | 04-24-2003 06:53 PM |
126 central locking | wazza | Tech Help | 1 | 02-19-2001 08:59 PM |
126 central locking | wazza | Tech Help | 3 | 02-17-2001 09:48 PM |
81 500se 126 central locking | wazza | Tech Help | 4 | 12-30-2000 06:10 PM |