|
|
|
#1
|
|||
|
|||
My driver side window switch appears to be stuck and will not roll up the window but will only go down. I need to get access to the rocker switch but can't seem to lift the wood panel up after removing the ring around the shift knob assembly. Am I missing something? Is the panel mounted?
Would appreciate any assistance. Thanks, Scott '90 560SEC |
#2
|
|||
|
|||
Open the ash tray
Remove the container remove the two screws that hold assmbly in and pull it out Lift the coin pocket from the front and roll it out Slide the wood trim forward about .5 inch and lift out. |
#3
|
|||
|
|||
Thanks Corky. I found a bad switch. That was a piece of cake.
Scott |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Window switches clean/repairable? | MBwD | Diesel Discussion | 9 | 09-04-2004 07:07 PM |
How to check if window switches OK? | TomO | Tech Help | 12 | 07-01-2004 12:19 PM |
R&R of center console trim tips for access to HVAC head and window switches | pookydink | Tech Help | 1 | 01-15-2003 07:49 AM |
R&R of center console trim tips for access to HVAC head and window switches | pookydink | Tech Help | 0 | 01-14-2003 09:29 PM |
Window Switches Sticky - Clean, or Replace? | David C Klasse | Tech Help | 3 | 03-27-2002 03:17 PM |