|
|
|
|
|
#5
07-15-2010, 04:58 PM
|
||||
|
||||
|
I just put in a new ABS Wheel sensor after replacing a ball joint.
The ABS system activated at very slow speeds, but otherwise seemed normal. The problem was that the ABS wheel sensor was not pushed in all the way. I could see a very small gap between the plastic part of the sensor and the spindle. Some gentle taps with a hammer and re-tightening of the alllen bolt fixed the problem.
__________________
1991 350SD (updated rods) Biodiesel B100 when I can find it. Dino when really cold outside 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ABS Problem '90 300TE 4matic | chesterloosee | Tech Help | 0 | 06-03-2004 12:09 PM |
| C200 ABS light problem | MB Nutter | Tech Help | 1 | 05-16-2003 04:30 PM |
| Cause of odd ABS problem tied to cruise control? | Ron Brooks | Tech Help | 3 | 01-03-2003 02:19 PM |
| W126 ABS Problem | Rich126 | Tech Help | 4 | 04-24-2002 09:02 AM |
| ABS help with 81' 380SE (126) from Germany | Gettin'_Old | Tech Help | 2 | 04-21-2002 07:11 PM |
Threaded Mode
