|
|
|
|
|
#3
09-11-2000, 08:20 PM
|
|||
|
|||
|
Guess I get to answer my own question.
The pulley assembly is held on the armature shaft by a 22mm bolt. Problem is, these bolts get frozen onto the shaft and one must hold the armature stationary in order to ratchet the bolt off. Quite difficult UNLESS you happen to have an impact wrench that will VIBRATE the bolt off. A guy at PepBoys did it for me with no problem, holding the armature assembly stationary by hand. That's the trick. It's all in the vibe. Steve Guilford 107 026 12 000677 107 024 12 011890 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The joys and sorrows of removing oil cooler lines | dmorrison | Diesel Discussion | 22 | 02-11-2016 11:58 AM |
| Removing door lock tumblers - 300E | Zeus | Tech Help | 31 | 03-02-2004 02:51 PM |
| Side airbags in a 1996? Need advice on removing door panel. | spinedoc | Mercedes-Benz SL Discussion Forum | 5 | 09-03-2003 11:00 AM |
| Procedure for removing steering wheel | Flavio | Tech Help | 4 | 05-15-2002 01:10 AM |
| Removing the Speedometer | JOHNSC16V | Tech Help | 2 | 12-19-2001 04:54 PM |
Threaded Mode
