|
|
|
|
|
#1
09-28-2000, 10:57 PM
|
|||
|
|||
|
The Bowden wire that adjusts the trans.control pressure is jammed and will not move This is on a 1982 300D-Turbo and happened after I had replaced the valve cover gasket and was re-connecting the linkage Everything hooked up okay, but the throtle pedal would not move. After disconnecting the Bowden wire from the transmission, The throtle pedal acted normal. Is there someway I can un-jam this connection? I have driven the car with the linkage disconnected, and the car does okay.Bill Lewallen Lexington, Ky.
|
|
#2
09-29-2000, 06:17 AM
|
|||
|
|||
|
Does the cable still move in the sheath when you pull on it? If it does, I'd guess you have the two cross rods over the valve cover to the swapped causing it to jam. If the cable doesn't move in the sheath...you've got it pinched under something.
Regards, Randy D. ------------------ W.R.Durrance ASE Master Tech Mercedes Tech 20 Years 68 250SE 68 SAAB 96 Ice Racer 69 300SEL 6.3 70 300SEL 3.5 81 300TDT
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Help, Please: 87 300SDL Trans Problem | pstutcher | Diesel Discussion | 8 | 07-25-2004 10:32 AM |
| Please, please, please help! 87 300SDL Trans Problem | pstutcher | Diesel Discussion | 2 | 07-21-2004 09:54 PM |
| Trans pressure gauge fittings? | wolf_walker | Diesel Discussion | 3 | 05-03-2004 01:43 PM |
| idle speed control, wiper trans, 3rd brake lght, rear speaker deck, window regulators | grey500se | Mercedes-Benz Used Parts For Sale & Wanted | 0 | 08-20-2003 02:54 PM |
| w126 280se Pressure Control Regulator Question | kennysin | Tech Help | 1 | 08-01-2003 08:23 AM |
Linear Mode
