|
Sprinter 3500 DIY rear brake job
I mostly hang out in Diesel Discussion. I usually post there, but a friend asked me to work on his Sprinter chassis motor home, so I figured I would post here. The rear brakes were down to the sensors. New parts (Zimmerman) were procured, and I did the job today. After removing the rear dual wheels, I loosened the bolts (19mm) holding the rotor and wheel mounting flange. I then removed the caliper bolts (15mm) and mounting bracket bolts (24mm). I removed the sensor wire so the caliper could hang out of the way. A little hammering on the rotor loosened it enough to be able to remove it and the flange.
|