Quote:
Originally Posted by 300GD
Thanks for the input, and I agree this is one screwed up job! Almost makes me wish I could swap this motor out for a good old OM617.
Could you elaborate on what you were saying about using slight upward pressure while turning?
|
I was using an extension on the deep socket I was using, and whenever I turned the plug back and forth I would also use a slight pulling up on the extension while turning. Its a little bit of a juggling act with one hand holding the socket on the end of the extension and the other hand keeping the top end connected to the wrench.
Those two plugs were so carbon bound that they would squeak when being moved in either direction.
12-23-2016, 01:34 PM
Threaded Mode
